具有光照鲁棒的图像匹配方法

针对现有的基于局部特征的图像匹配算法对光照变化敏感、匹配正确率低等问题，提出一种具有光照鲁棒性的图像匹配算法。首先使用实时对比保留去色（RTCP）算法灰度化图像，然后利用对比拉伸函数模拟不同光照变换对图像的影响从而提取抗光照变换特征点，最后采用局部强度顺序模式建立特征点描述符，根据待匹配图像局部特征点描述符的欧氏距离判断是否为成对匹配点。在公开数据集上，所提算法与尺度不变特征变换（SIFT）算法、加速鲁棒特征（SURF）算法、"风"（KAZE）算法和ORB算法在匹配速度和匹配正确率上进行了对比实验。实验结果表明：随着图像亮度差异的增加，SIFT算法、SURF算法、"风"（KAZE）算法和ORB算法匹配正确率下降迅速，所提算法下降缓慢并且正确率均高于80%；所提算法特征点检测较慢和描述符维数较高，平均耗时为23.47 s，匹配速度不及另外四种算法，但匹配质量却远超过它们。对实时性要求不高的系统中，所提算法可以克服光照变化对图像匹配造成的影响。     

Efficiency and effectiveness enhancement of an intercooler of two‐stage air compressor by low‐cost Al2O3/water nanofluids

The present study was aimed to utilize low‐cost alumina (Al₂O₃) nanoparticles for improving the heat transfer behavior in an intercooler of two‐stage air compressor. Experimental investigation was carried out with three different volume concentrations of 0.5%, 0.75%, and 1.0% Al₂O₃/water nanofluids to assess the performance of the intercooler, that is, counterflow heat exchanger at different loads. Thermal properties such as thermal conductivity and overall heat transfer coefficient of nanofluid increased substantially with increasing concentration of Al₂O₃ nanoparticles. Specific heat capacity of nanofluids were lower than base water. The intercooler performance parameters such as effectiveness and efficiency improved appreciably with the employment of nanofluid. The efficiency increased by about 6.1% with maximum concentration of nanofluid, that is, 1% at 3‐bar compressor load. It is concluded from the study that high concentration of Al₂O₃ nanoparticles dispersion in water would offer better heat transfer performance of the intercooler.     

餐厨污水就地处理与中水回用工艺的探索与实践

以无锡某厂食堂污水处理及中水回用为例,探讨采用"隔油+混凝沉淀+A^2/O+MBR"工艺就地处理餐厨污水,并将出水回用于厂区冲厕可行性。经过78 d的调试,该工艺实现了餐厨污水中污染物的去除,COD小于50mg/L,NH4^+-N质量浓度小于5 mg/L,总氮小于10 mg/L,总磷小于0.5 mg/L,大肠杆菌数小于2个/L,基本满足中水回用要求。经计算吨水处理成本9.83元,含电费、药剂费、人工费、污泥处理费及膜更换费用。结合中水回用节省自来水后计算吨水处理综合成本为5.23元,大幅降低公司对市政供水的依赖,降低公司用水成本。     

上榆泉煤矿煤泥水多参数在线检测系统应用研究

针对上榆泉煤矿煤泥水性质参数人工检测周期长、误差大、滞后性严重的问题,采用多参数传感器和PLC,开发了煤泥水多参数在线检测系统。经过8 h稳定运行,平均结果显示该厂煤泥水参数为pH值为7.71、浓度9.45%、中值直径(D50)39.56μm、流量2 440 m3/h、水质硬度428.94 mg/L,与人工检测结果相一致。应用结果表明,该检测系统能够实现煤泥水多参数在线监测和数据分析功能,使煤泥水的处理更高效。     

饱和尾粉砂动孔隙水压力发展特性试验研究

采用动三轴仪对内蒙古某尾矿库尾粉砂进行了动强度试验,研究了围压、相对密实度及固结比对动荷载作用下尾粉砂中孔隙水压力发展特性的影响。研究结果表明,随着固结比、相对密实度、围压的增大,动荷载作用下饱和尾粉砂孔压增长曲线形状由陡峭转变为平缓。随着围压及固结比增大,试样动力破坏形式从以孔压值为主要表征指标的液化破坏,转化为以动剪应变为主要破坏形式的软化破坏。动荷载作用下发生液化破坏的饱和尾粉砂孔压增长过程分可为初始增长阶段、稳定增长阶段和快速增长至破坏阶段,孔压增长曲线表现为明显的反S型,本文采用双对数函数对该试验孔压增长曲线进行拟合,结果表明该模型可以较好地模拟尾粉砂在动荷载作用下的孔压发展规律。     

燃气热水器在无回水管水路中实现零冷水的方案研究

本文分析了燃气热水器行业针对无回水管水路系统实现零冷水功能的现有技术方案,指出现有技术方案存在的一些缺陷,并结合试验研究,对无回水管水路系统提出了一套全新的实现零冷水功能的技术解决方案。     

可持续煤矿矿井水处理与资源化技术综述

煤矿开采过程中会产生大量的废弃矿井水,不仅造成水资源的大量浪费,而且还威胁着矿区生态环境。本文综述了我国常见矿井水的常规处理方法,以及将矿井水视为水资源的可持续矿井水水处理与资源化技术,首次提出以“时间维度和空间维度”对矿井水进行全时空处理,并着重阐述了矿井水分级处理、分质利用技术,反渗透浓水处理与资源化技术,煤泥处理与资源化技术,以及重金属回收与利用技术等,对煤矿区矿井水处理与资源化利用具有指导意义。     

Interface engineering of copper-cobalt based heterostructure as bifunctional electrocatalysts for overall water splitting

It is of great significance to develop highly active and cost-effective electrocatalysts for the oxygen evolution reaction and hydrogen evolution reaction in alkaline solution. Herein, we report an interface engineering strategy to fabricate 3D hierarchical CuCo₂O₄@CuCo₂S₄ heterostructure catalysts with efficient synergistic effects for water splitting. Owing to the special nano-architectures with abundant active interfaces, the as-prepared CuCo₂O₄@CuCo₂S₄ catalysts exhibit superior electrochemical activity and prominent electrochemical stability, with a small overpotential of 240 and 101 mV for oxygen and hydrogen evolution reactions to deliver a current density of 10 mA cm⁻², respectively. Remarkably, the CuCo₂O₄@CuCo₂S₄ materials directly applied as both anode and cathode electrode demonstrate excellent water splitting performance, achieving 10 mA cm⁻² at a low cell voltage of only 1.53 V, outperforming the integrated state-of-the-art RuO₂||Pt/C couple (1.56 V). Moreover, density functional theory calculations suggest that the excellent overall water splitting property of CuCo₂O₄@CuCo₂S₄ is attributed to a large amount of hierarchical hetero-interfaces, giving rise to effective adsorption and cleavage of H₂O molecules on the catalyst surface. This work represents a general strategy to exploit efficient and stable hybrid electrocatalysts for renewable energy applications by rational catalyst interface engineering.     

浅析火力发电厂汽水系统中内径管与外径管的设计选择

按照管道加工工艺的不同,管道可分为内径控制管和外径控制管。通过热轧工艺生产的外径控制无缝钢管,可满足火力发电厂汽水系统中绝大部分管道的使用要求。对于超(超)临界机组的主蒸汽和高温再热蒸汽管道采用的P91/P92材质的大口径厚壁无缝钢管,由于对材料性能和加工工艺有特殊要求,因此宜采用内径控制管。